Skip to content
Repair

No Hot Water From a Gas Water Heater? 7 Things to Check

Cold shower this morning? Before you panic, run through these seven quick checks. Several of them take less than five minutes.

By Covina Water Heater Pros · · 2 min read

No Hot Water From a Gas Water Heater? 7 Things to Check

Quick answer

When a gas water heater stops making hot water, the cause is usually an extinguished pilot light, a faulty thermocouple or flame sensor, a closed gas valve, a tripped flammable-vapor sensor, or a failed gas control valve. Relighting the pilot fixes it in many cases; if it keeps going out, a part needs replacing.

Need it fixed today? Call (626) ***-****

Quick Safety Check

Safety first: If you smell gas (a rotten-egg odor) near the heater, don't try to relight anything. Leave the house and call SoCalGas or 911 from outside. Read our gas smell guide.

7 Things to Check

1. Is the pilot light on?

Look through the small window near the bottom of the tank. No flame means the pilot is out. Follow the lighting instructions on the label to relight it. Newer models use a push-button igniter.

2. Is the gas on?

The gas shut-off valve on the supply line should be parallel to the pipe. Also check that other gas appliances like the stove still work.

3. Is the control knob set correctly?

Someone may have bumped it to VACATION or PILOT. Turn it back to your normal setting, usually around 120°F.

4. Does the pilot go out after you release the knob?

That points to a worn thermocouple or thermopile, the part that tells the gas valve the pilot is lit. It's a common and affordable repair. More in our pilot light guide.

5. Is the FVIR sensor tripped?

Most heaters built after 2003 have a flammable vapor sensor that shuts the unit down if it detects fumes or if the air intake screen is clogged with lint and dust. Some need a reset; others need a new sensor.

6. Is the venting blocked?

Power-vent models shut off if the vent is blocked or the blower fails. Check for error lights on the blower.

7. Is the gas control valve working?

If the pilot stays lit but the main burner never fires, the gas control valve or its thermostat may have failed. This part should be replaced by a licensed technician.

Still no hot water after these checks?

Talk to a local Covina technician now. Honest advice, upfront pricing.

(626) ***-****

When It's Not a Quick Fix

If you've relit the pilot more than once this week, something is wrong. Repeated outages often point to a failing thermocouple, a draft problem or a dirty pilot tube. On older tanks, a bad gas valve can cost enough that replacement is the better investment.

Call us and describe what you see. Many no-hot-water calls in Covina are fixed in a single visit with parts we carry on the truck.

This article is general information for Covina-area homeowners. Gas, venting and electrical work should be done by a licensed professional. For help with your specific water heater, call (626) ***-****.

Frequently Asked Questions

A standard 40- or 50-gallon gas tank usually takes 30–60 minutes to fully reheat after the pilot is relit.
The usual culprits are a worn thermocouple, a dirty pilot orifice, drafts, a clogged air intake, or a faulty gas control valve.
Not usually, but if there's a gas smell, water leaking, or you have infants or elderly family at home, call for same-day service.

Cold Showers? We Can Help Today.

Same-day gas water heater repair across Covina and the San Gabriel Valley.

Call (626) ***-****
Call Now Free Quote